Set up Mobility Print with a Site Server

Mobility Print works on a Site Server in online and offline mode if you are running PaperCut 17.1 or higher.

When Mobility Print was installed in PaperCut NG/MF 17.0 but is now running in 17.1 or later

If you have set up Mobility Print with a Site Server using PaperCut NG/MF 17.0, and have since upgraded to PaperCut 17.1 or later, you need to perform the changes described below. The upgrade enables Mobility Print to work with a Site Server when the connection with the Application Server is down.

1. Open the following file in a text editor: [app-path]/data/config/papercut-server.conf

2. Remove the lines starting with:

   ApplicationServer=

   ApplicationServerPort=

3. Save the file.

4. Restart the PaperCut Mobility Print service.

This ensures that PaperCut Mobility Print works in offline mode.

For PaperCut NG/MF 17.0 only

If you are running PaperCut NG/MF 17.0, you need to make the following changes to config files for Mobility Print to work.

1. Open the following file in a text editor:

   [app-path]/data/config/papercut-server.conf

2. Set the following values:

   ApplicationServer=[Application Server IP address]

   ApplicationServerPort=9191

3. Save the file.

4. Restart the PaperCut Mobility Print service.